An antenna is an electronic device or a component that is designed to send and receive waves. It is a center fed element for transmitting and receiving radio frequency energy. A TV antenna is an antenna that transmits and receives electromagnetic energy. A television antenna is basically a low-tech device. It consists of a series of elemen...
The television sets are incomplete without antennas. It is the antennas
that transmit the signals into electromagnetic waves and broadcast the visuals
on the television. However, the television antennas are powerful and need to be
handled with great care and caution. The individuals may suffer from physical
injury if they do not handle the ...
There are many types of TV antenna mounts available in the market. To choose the best among them is a big deal. Among them few are stated below for getting the best deal. 1. Supported Mast Installation – this type of mounts are an excellent way to mount an antenna to a house or building. They provide a strong and rigid mount for the antenna, and...
Amplifier is an electronic device using transistors or electron tubes. This is used to produce and amplification of an electrical signal. It also increases and restores the strength of the signals passing through it. It involves the controlled conduction of electrons especially in a gas or vacuum or semiconductor. An amplifier uses a small amount o...
The satellite antenna is an artificial satellite, which is placed in space. The main purpose of satellite antenna is to serve communication. It solves the purpose of reconnaissance with the use of radio at microwave frequencies. An earth station is located on the ground, which use to transmit the radio waves. The satellite antenna use geosynchronou...
The satellite antenna alignment is used to calculate the angles necessary for installing satellite dishes. The major difference from similar software is the possibility to calculate the position for all satellites at once. One can get a clear picture about what satellites can be physically detectable from the location where the dish will be install...
These are the antennas that are placed outside the house. An outdoor antenna can be slightly tilted to get better results of receiving signals. These antennas occupy large space. This gets signals directly from the satellite. Some of the outdoor antennas are good at receiving reflected signals. Outdoor antennas can be placed at the rooftop, railing...
A loop antenna is primarily used for the AM broadcast and the bands of Long wave. Mainly there are two types of loop antennas, among them one is ferrite bar same as the am radio and other is in the form of air core. A loop antenna is multidirectional. A loop antenna will receive the signals on the opposite side and off side of the antenna signal wi...
Television antenna signals are strongest and reception is generally the best when the station's transmitting tower is in clear line of vision with the home receiving the broadcast. Mountains, buildings or trees that block this line of sight tend to weaken and degrade the received signal. The signal also becomes weaker as it travels further from the...
Reception is a process of receiving electromagnetic signals through antennas. If the antenna is placed next to the transmitter then there would be a perfect reception of signals. But it is not possible for everyone to have his or her antenna next to the transmitter. There will be a proper reception of signals in the nighttime. This is because there...